Dip Switch - Star Micronics SP500 Series User Manual

■ DIP switch

SW No.
1 Always ON
2 Auto Cutter *1
3 Always ON
4 Command emulation
5 USB mode *2
6
7 Always ON
8
*1 The factory settings for enabling/disabling the auto cutter are as follows.
Models without auto cutter: Invalid (Switch 2 = on)
Models with auto cutter: Valid (Switch 2 = off)
Note: Do not enable the auto cutter for models without the auto cutter (i.e.,
models with a tear bar). A mechanical error will occur.
*2 USB interface only
Function
– 116 –
Factory presetting: All ON
ON
Should be set on
Invalid
Should be set on
Star ESC/POS
Printer class Vendor class
Should be set on
*1
OFF
Valid