Cutting Grass - Shindaiwa T242X Owner's/Operator's Manual

Operation

Cutting Grass

Units equipped with a trimmer head
Your Shindaiwa unit may be equipped with one of several Shindaiwa trimmer head models, each with
features for specific applications and/or operational requirements
For proper operation, always refer to the instructions accompanying the trimmer head being used. Available
trimmer head styles include:
■
Semi-automatic. Trimmer line is advanced when the operator taps the trimmer head on the ground dur-
ing operation.
■
Manual. The operator advances line manually with the grass trimmer stopped.
■
Fixed. The operator must stop the unit and add new lengths of trimmer line manually.
■
Flail. This device, designed for clearing weeds and light brush, features three nylon blades attached to
the head by pivots.
Additional hardware may be required to mount the Fixed Line or the Flail type trimmer heads.
CAUTION!
Do not push the rotating line into trees, wire fences or any material that could tangle or break line ends
Engine Operating Speeds
Operate the unit at full throttle while cutting grass.
CAUTION!
Operation at low RPM can lead to premature clutch failure.
CAUTION!
Operation of trimmer head without a debris shield and using excessive line length can lead to premature
clutch failure.
Trimming and Mowing Grass
Hold the trimmer so the trimmer head is angled slightly into the area to be cut. To
ensure maximum trimmer-line service life, cut only with the tip of the trimmer line. Cut
grass by swinging the trimmer from left to right. Keep the trimmer head horizontal.
Edging
Tilt the handle about 100° to the left (from horizontal) and move forward, holding the trimmer
vertically as shown.
T242X Trimmer
NOTE:
NOTE:
19