DOS 1 (liquid detergent)
Setting the detergent dosage
The dosage concentration only needs to be set for liquid detergents. Set the
concentration according to the detergent manufacturer's recommendations.
Do not change the setting if you are using powdered detergent in the door
dispenser.
Step
^ Press the 0 button until E02 appears in
the display.
^ Turn the program selector to
"Inorganica".
Using door dispenser
Using DOS module
^ Press or hold down the ß button until
the required value appears in the
display, e.g., 0.5.
Dosage concentration setting:
Priming the dosage system
The dosage system does not need to be primed (cleared of air) unless:
– the dosage concentration is being set for the first time,
– the liquid detergent container was inadvertently completely emptied .
Step
^ Press the 0 button until E02 appears
in the display.
^ Turn the program selector to "Custom". d§1
^ Press the ß button.
^ Exit the programming mode.
Start "Rinse" program.
Programming functions
Display / Result
E02
10 = 10 sec dosage length
1.00 = 1.0 % dosage concentration
0.50 The dosage time / dosage
concentration is now set.
Display / Result
E02
The dosage system will be primed
automatically. Priming is complete
when 0 appears in the display.
This will rinse away any agents that
entered the wash cabinet during
priming.
37