Registering A Handset To A Base Unit - Panasonic KX-TCD650BX Operating Instructions & Quick Manual

Digital cordless phone
Table of Contents

Advertisement

650bx engversion 19 6 02
Operating Additional
Handsets
Additional KX-A120EX handsets are
available to purchase separately. Up
to 6 handsets can be registered to a
single base unit. Using additional
handsets allows you to have an inter-
com call while simultaneously con-
ducting a call to an outside line.
Operating Additional
Base Units
You can register and operate your
handset with up to 4 base units. Each
base unit forms 1 radio cell. If the indi-
vidual bases are
linked to the
same tele-
phone
line then
you can
extend
the oper-
ating
range of
the system
Radio Cell
Eg.
Additional
handsets
(KX-A120EX)
registered with
2 base units.
transfer calls between bases (only
between handsets linked to the same
base unit).
19/6/02
6:59 am
2
1
3
by posi-
tioning the
bases so
that the
two
radio
cells
4
overlap.
If the
handset is
5
set to AUTO
base selection, then in
standby mode the hand-
set will automatically
swap to the second base
if the range on the first
base is exceeded.
It is not possible to
Page 17
NOTE: Calls are disconnected
when the handset moves from one
radio cell to another.
Registering a Handset
to a Base Unit
The handset supplied with the base
unit is already registered. If an optional
handset is purchased, it must be regis-
tered as follows.
! Charge the optional handset
batteries for 15 hours before
initial use.
1
From the Standby mode, Z
2
S / U
U to select s s e e t t t t i i n n g g h h s s
Z S
Z
(Setting Handset).
3
V .
Z
Z V
4
S / U
U to select:
Z
Z S
registration
(Registration):
5
V .
Z
Z V
register hs
(Register Handset):
V .
Z V
Z
Z and hold Ï
Ï on the base unit
Z
for 10 seconds. A base registration
tone sounds
! Handset must be registered with-
in 1 minute. If over 1 minute
± , then restart registration.
Z ±
Z
S / U
U to select b b a a s s e e 1 1 - - 4 4
Z
Z S
(base 1-4).
V .
Z
Z V
Enter base unit PIN (4 digits -
factory preset is 0000).
V .
Z
Z V
When handset and base unit
connect a confirmation tone
sounds.
If handset registration is not
successful within 5 minutes, an
error tone sounds.
17
V .
Z V

Advertisement

Table of Contents
loading

Table of Contents