MSI MS-7357 (V1.X) Manual page 58

M S-7357 M ainboard
DRAM TRFC
This setting determines the time RFC takes to read from and write to a memory
cell.
DRAM TWR
Minimum time interval between end of write data burst and the start of a
prechargecommand. Allows sense amplifiers to restore data to cells.
DRAM TWTR
Minimum time interval between the end of write data burst and the start of a
column-read command. It allows I/O gating to overdrive sense amplifiers before
read com-mand starts.
DRAM TRRD
When the Timing Mode is set to [Manual], the field is adjustable. Specifies theactive-
to-active delay of different banks. Available settings: [Auto], [2T], [3T], [4T].
DRAM TRTP
Time interval between a read and a precharge command.
M emory Hole
In order to improve performance, certain space in memory can be reserved for
ISA peripherals. This memory must be mapped into the memory space below
16MB. W hen this area is reserved, it cannot be cached.
FSB/Memory Ratio
This setting control the ratio of CPU FSB / DRAM Clock Ratio to enable the CPU &
DRAM to run at different frequency combinations. Please note that the setting options
vary according to the CPU FSB Clock preset.
Adjusted DDR Memory Frequency
This item shown the DDR memory frequency after you adjusted. You need to restart
the system to load the new memory frequency you choose. (read only)
Adjust PCIE Frequency
This field allows you to select the PCIE frequency (in MHz).
Auto Disable DIM M/PCI Frequency
This item is used to auto detect the DIMM/PCI frequency. Settings: [Enabled], [Disabled].
CPU Voltage
This item allows you to increase the CPU voltage.
3-22