Installation; Positioning And Connection - Indesit IN CH 310 AA VE I UK Operating Instructions Manual

Installation

!
GB
!

Positioning and connection

Positioning
Electrical connections
Assistance
!
!
!
! The manufacturer declines any liability should these
safety measures not be observed.
2
see
see Assistance
WARNING: THIS APPLIANCE MUST BE EARTHED.
Replacing fuse covers:
When replacing a faulty fuse, a 13amp ASTA approved
fuse to BS 1362 should always be used and the fuse cover
re-fitted. If the fuse cover is lost, the plug must not be used
until a replacement is obtained.
Replacement fuse covers:
If a replacement fuse cover is fitted, it must be of the correct
colour as indicated by the coloured marking or the colour that
is embossed in words on the base of the plug.
Changing the plug: Removing the plug
If your appliance has a non-rewireable moulded plug and
you should wish to remove it to add a longer cable or to re-
route the mains cable through partitions, units etc. please
ensure that either:
- The plug is replaced by a fused 13amp rewireable plug
bearing the BSI mark of approval.
or
- The mains cable is wired directly into a 13amp cable outlet,
controlled by a switch (in compliance with BS 5733) which is
accessible without moving the appliance.
Disposing of the plug
Cut off and dispose of the supplied plug if it does not fit
your socket. The cable should be cut as close as possible
to the moulded plug. Remove the fuse.
WARNING: To avoid a shock hazard do not insert the
discarded plug into a socket anywhere else.
Fitting a new plug
IMPORTANT:
WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE...
Green and Yellow
Blue
Brown
As the colours of the wires in the
mains lead may not correspond with
the coloured markings identifying the
terminals in your plug, proceed as
follows:
- Connect Green and Yellow wire to
'E' or or coloured Green and Yellow.
- Connect Brown wire to terminal marked 'L' or coloured
red or brown.
- Connect Blue wire to terminal marked 'N' or coloured
Black or Blue.
If a 13amp plug (BS 1363) is used it must be fitted with a
13amp fuse. A 15amp plug must be protected by a 15amp
fuse, either in the plug or adaptor or at the distribution board.
If you are in any doubt about the electrical supply to your
machine, consult a qualified electrician before use.
CE Marking certifies that this appliance conforms to the
following EEC directives :
Low Voltage Equipment - 73/23/EEC & 93/68 EEC
Electromagnetic Compatibility 89/336/EEC, 92/31/EEC &
93/68/EEC
- Earth
- Neutral
- Live
terminal marked