HTC Snap User Manual page 57

Option Allows you to
Set a time length for displaying the captured image or video on the Review screen
before automatically saving it and returning to the live camera screen. Select No Limit
Review Duration
to allow the picture to be displayed until you choose to take another action. Select No
Review
Choose a special effect such as Grayscale , Sepia , or Negative to apply to your photos
or video clips.
Effect
Note: White Balance cannot be applied if an Effect has already been applied.
Select a metering mode to allow the camera to measure the amount of light in the
center and around the image and calculate the best-fit exposure value before
Metering Mode
capturing. Choose either Center Area to measure light using the center area of the
image or Average to measure light using the area all around the image.
Set a prefix to image or video filenames.
When Default is selected as the prefix, the filename of each new captured file is set
to "IMAGE" or "VIDEO" followed by a sequential number, for example:
IMAGE_001.jpg. You may also choose to prefix filenames using either the current
Prefix
Date or Date & Time .
If you set the camera to save captured photos to a storage card, the prefix
Note:
cannot be selected. Captured photos will be named using the DCIM (Digital Camera
Images) naming standard.
Counter Select Reset to reset the naming counter to 1.
When taking indoor shots, flicker on the camera screen may be caused by
interference from fluorescent lighting. To reduce flicker, change the flicker adjustment
Flicker Adjustment
setting to the proper frequency ( 50Hz or 60Hz ) of the location where your phone is
being used.
Direction
Choose in what direction images will be stitched in a panorama.
(Panorama mode
only)
Stitch Count
Select the desired number of snapshots to be taken and stitched into a panorama.
(Panorama mode
only)
By default, templates are stored in the \My Documents\Templates folder on the
Template Folder
phone's main memory. If you transferred some templates to a storage card (using
(Picture Theme
File Explorer), set this option to Main + Card to specify that templates are located in
mode only)
both the main memory and the storage card.
Show Reminder
Select On to be prompted to set the picture to a contact after taking a contact picture.
(Contacts Picture
Select Off to disable the prompt.
mode only)
About Display the camera's firmware information.
to immediately return to the live camera screen after capturing.
2D. Camera and Multimedia 49