Mitsubishi Electric Unisen LT-52151 Owner's Manual page 13

Setting Up TV Inputs, continued
About Auto Input Sensing/
Auto Output Sensing
This TV's Easy Connect™ Auto Input Sensing feature
detects most connections automatically. The excep-
tions are:
• A connection on the
• An HDMI device that is powered off. Power on
the device to ensure detection.
Auto Sensing for Most Devices
When you first connect a device, the TV will:
a. Detect the connected device and automatically
switch to it.
b. Prompt you to identify the device type.
c. 153 and 249 Series. Prompt you to perform
NetCommand set-up for the device, if available.
d. Repeat these steps for any other newly detected
devices.
When You First Connect a Device
• Most Device Types.
the on-screen list. The device type you select here
will appear as a device icon in the Activity menu.
• A/V Receiver
- The TV detects audio connections on the
AUDIO OUTPUT jack and the right (red) AVR
AUDIO OUTPUT jack.
- For an HDMI A/V receiver, select
the list of device types if the A/V receiver is
not recognized automatically.
• HDMI CEC Devices Compatible with the TV's
HDMI Control Feature. Compatible CEC-
enabled HDMI devices are often recognized auto-
matically by the TV. HDMI Control may allow you
to control some functions of a CEC-enabled device.
See Appendix B, "HDMI Control of CEC Devices."
ANT input
Select the device type from
DIGITAL
AVR from
1. Basic Setup and Operation
New Device Found screen for a device with HDMI
control enabled. Select On to enable the TV's CEC
control of the device. In some cases, as in the
example above, you will also be prompted to select a
device name.
Tips on Auto Sensing
• Choose a different name for each input.
• The antenna input (
although you can turn off the unused antenna
input in the Inputs > Name menu.
• Change the device type displayed in the
menu in the Inputs > Name menu (page 50). You
must switch to a different input before changing
the device type.
• 153 and 249 Series.
mand IR codes will be erased if you change the
device type in the Inputs > Name menu.
Reactivating Auto Sensing for an HDMI Input
When you disconnect an HDMI device, Auto Sensing is
disabled until you perform these steps.
1.
Switch to any input other than the one to be dis-
connected.
2. Disconnect the HDMI device.
3. Delete the removed HDMI device in the
Name menu (see "Removing an HDMI Device,"
page 77).
4.
Connect the new HDMI device and the
Device Found screen will display.
ANT) is never detected,
Activity
Any "learned" NetCom-
Inputs >
New
13