Motech LPS 305 User Manual page 16

Step 4: Measure the DC current from +out terminals (+ and COM1) with the DMM and keyin the
value (i.e. if the DMM shows 0.728A, then keyin 0.728 ) followed by the "ENTER" key. The
following message will then appear on the LCD:
Step 5: Repeat step 4. Keyin the measured value (i.e. if the DMM shows 2.491A then keyin 2.491)
followed by the "ENTER" key. The following message will then appear on the LCD:
Step 6: Measure the DC voltage from –output terminals ( - and COM1) with the DMM and keyin the
measured value (i.e. if the DMM shows 9.624V then keyin 9.624) followed by the "ENTER"
key.
The following message will then appear on the
Step 7: Repeat step 6.Keyin the measured value (i.e. if the DMM shows 30.036V, then keyin 30.036)
followed by the "ENTER" key. The following message will then appear on the LCD:
CV
+I Hi=2.491
CC
CV
ADC GET=02579
CC
CV
ADC GET=01039
CC
CV
-V Lo=09.624
CC
CV
ADC GET=03099
CC
CV
-V Hi=30.036
CC
INDEP
TRACK
5V
3.3V
INDEP
TRACK
5V
3.3V
INDEP
TRACK
5V
3.3V
13