Download Print this page
White Rodgers 50T35-743 Installation Instructions

White Rodgers 50T35-743 Installation Instructions

Integrated furnace control

Advertisement

Quick Links

Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE
INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL
INJURY AND/OR PROPERTY DAMAGE.
The 50T35-743 Integrated Furnace Control is a replacement for Goodman B18099-06, B18099-08, B18099-10 and
B18099-13 HSI modules
Installation should be done by a qualified heating and air
conditioning contractor or licensed electrician.
If in doubt about whether your wiring is millivolt, line, or low
voltage, have it inspected by a qualified heating and air
conditioning contractor or licensed electrician.
Do not exceed the specification ratings.
All wiring must conform to local and national electrical
codes and ordinances.
This control is a precision instrument, and should be
handled carefully. Rough handling or distorting compo-
nents could cause the control to malfunction.
Following installation or replacement, follow
manufacturer's recommended installation/service instruc-
tions to ensure proper operation.
CAUTION
Do not short out terminals on gas valve or pri-
mary control. Short or incorrect wiring may dam-
age the thermostat.

INSTALLATION INSTRUCTIONS

Failure to comply with the following
warnings could result in personal injury
or property damage.
FIRE HAZARD
• Do not exceed the specified voltage.
• Replace existing control with exact model and
dash number.
• Protect the control from direct contact with water
(dripping, spraying, rain, etc.).
• If the control has been in direct contact with water,
replace the control.
• Label all wires before disconnection when servic-
ing controls. Wiring errors can cause improper
and dangerous operation.
• Route and secure wiring away from flame.
SHOCK HAZARD
• Disconnect electric power before servicing .
• Ensure proper earth grounding of appliance.
• Ensure proper connection of line neutral and line
hot wires.
EXPLOSION HAZARD
• Shut off main gas to appliance until installation is
complete.
White-Rodgers is a division
of Emerson Electric Co.
www.white-rodgers.com
50T35-743
Integrated Furnace Control
DESCRIPTION
PRECAUTIONS
WARNING
PART NO. 37-6533A
0414

Advertisement

loading

Summary of Contents for White Rodgers 50T35-743

  • Page 1: Installation Instructions

    INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE. DESCRIPTION The 50T35-743 Integrated Furnace Control is a replacement for Goodman B18099-06, B18099-08, B18099-10 and B18099-13 HSI modules PRECAUTIONS Installation should be done by a qualified heating and air WARNING conditioning contractor or licensed electrician.
  • Page 2 TIME OFF STATUS JUMPER Install the 50T35-743 module. Reconnect the edgecard connector making sure of good contact. Push the 9 pin connector into the HSI module. It can go in only one way. DO NOT force.