Table of Contents
Advertisement
Oakleaf Woodburning stove
d. Optional Blower Installation
The optional blower kit #1-00-797032 installs easily to
the rear of the Oakleaf.
Hold the blower assembly into place and secure it
with the two bolts provided. You'll need a 3/8" wrench
or socket to tighten the bolts.
Notice: When installing the optional blower, the
upper rear shield must be moved upward to create
the air passage.
Loosen the eight screws to remove the rear shield.
Raise the shield to the upper set of holes, re-install
the shield, and tighten the screws.
WARNING
ROuTE POWER CORd AWAy fROM THE APPLIANCE.
dO NOT RuN THE CORd uNdER OR IN fRONT Of
THE APPLIANCE.
Plug the blower into a properly grounded electrical
outlet.
You can turn the blower on at any time using the
rocker switch on the rear of the blower housing. Set-
ting the switch to "AUTO" will keep the blower off until
there is a significant amount of heat from the stove.
In this setting, the blower will also shut off when the
stove cools. Keep the blower on low speed or off dur-
ing low fires. As you get out of the low burn range, the
speed can be set wherever desired, or kept off.
Save These Instructions
secure blower with one bolt on each
end of the mounting plate.
E. Optional Rear-vent Rear shield
Whenever a rear vent configuration is used, the upper
rear heat shield, #1-00-797070 must be purchased
and installed, to accomodate the flue collar. There
are eight screws that secure the existing shield.
You'll need to break away the tabbed portion of the
lower shield flue cut-out. Remove the screws from
the top-vent shield and install the rear vent shield in
it's place. Height adjustment for blower use is done
the same as with the top-vent shield in place. See
D. Optional Blower Installation (above) for detailed
instructions.
f. Optional Bottom Heat shield
Part #1-00-797058 must be purchased and installed
whenever the Oakleaf is installed on a protected com-
bustible floor. The shield installs on four bolts that are
protruding downward from the base of the stove body.
Slide the shield under the stove from the back, as
this is the only way it will fit. Lift into place guiding the
bolts through the holes in the shield and secure with
the nuts that are included with the shield.
3-90-798
If not installing the
optional blower, the
upper knockout will
need to be removed.
shown with lower shield
knockout removed.
Dry Seasoned Wood Only!
23
Advertisement
Table of Contents
