Lenovo ThinkStation Hardware Maintenance Manual page 64

Diagnostic Error Code
005-016-XXX Video Simple Pattern test failure
005-024-XXX Video Addressing test failure
005-025-XXX Video Checksum Value error
005-027-XXX Video Configuration/Setup error
005-031-XXX Video Device Cable failure
005-032-XXX Video Device Controller failure
005-036-XXX Video Register error
005-038-XXX System BIOS extension failure
005-040-XXX Video IRQ failure
005-195-XXX Video Test aborted by user
005-196-XXX Video test halt, error threshold exceeded
005-197-XXX Video test warning
005-198-XXX Video test aborted
005-199-XXX Video test failed, cause unknown
56
ThinkStation Hardware Maintenance Manual
FRU/Action
1. Video Ram
2. Video card, if installed
3. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Run Setup
2. Video drivers update
3. Video card, if installed
4. System board
1. Video cable
2. Monitor
3. Video card, if installed
4. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
1. Video card, if installed
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 39
2. Re-run test
3. Replace the component called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 39
2. Flash the system and re-test. See "Flash update
procedures" on page 285
3. Go to "Undetermined problems" on page 73
1. Go to "Undetermined problems" on page 73
2. Flash the system and re-test. See "Flash update
procedures" on page 285
3. Replace component under function test