Tascam 112 MKII Specifications page 3

112 II
MK
SPECIFICATIONS
Track System: 4-Track, 2-Channel Stereo
Head Configuration: 1 Record/ Repro combination
head (permalloy)/Half Track/
1 ferrite Erase head
Tape Type: Compact Cassette tape C-30
to C-90 (Normal/Cr0
Tape Speed: 4.8 cm/sec (1-7/8 ips)
Motors: 1 DC servo capstan motor;
1 DC reel motor; 1 DC
ancillary motor
±12% (approx.)
Pitch Control:
Line Input: • Rear RCA jack/front 1/4" jack
Nominal input level: -10 dBV (0.3 V)
Minimum input level: -18 dBV (126 mV)
Input impedance: 20k ohms, unbalanced
• XLR-type jack
(optional; –LA-112 required)
Nominal input level: +4 dBV (1.23 V)
Input impedance: 10k ohms, balanced
Line output: • RCA jack (rear)
Nominal output level: -10 dBV (0.3 V)
Maximum output level:-2 dBV (0.8 V)
Output impedance: 100 ohms
Load impedance: 25k ohms or more
• XLR-type jack
(optional; –LA-112 required)
Nominal output level: +4 dBV (1.23 V)
Minimum load
impedance: 600 ohms
Headphone Output: 100 mW (8-ohm load)
Bias/Erase Frequency: 100 kHz
3180 µs + 70 µS (Cr0
Equalization:
3180 µs + 120 µS (Normal)
Reference Recording
Level: 250 nWb/m = 0 VU (315 Hz)
(EIAJ); With Dolby:
200 nWb/m = -1 VU
Remote Connector: 25-pin D-sub
For more information about other TASCAM
FAXBACK literature, call 1-800-827-2268.
©1997 TEAC America, Inc. All rights reserved. 7733 Telegraph Road, Montebello, CA 90640 (213) 726-0303
TEAC Canada Ltd., 5939 Wallace Street, Mississauga, Ontario L4Z 1Z8 Canada (905) 890-8008
TEAC Mexico, S.A. de C.V., Priva de Colina #18, Colonia del Carmen, Coyoacan, Mexico, D.F. 04100 (525) 658-1943
FAXBACK Index# 1340 2/97
Power Requirements:
Power consumption:
Weight:
/Metal)
2
TYPICAL PERFORMANCE
Speed Accuracy:
Wow and Flutter
Fast Winding Time:
(Overall, EIAJ,
without NR):
Distortion
Signal-to-Noise Ratio
(Metal tape):
Channel Separation
Erase Ratio
In these specifications, 0 dBV is referenced to 1 Volt, and 0
dBm is referenced to 0.775 Volt. Actual voltage levels are
shown in parenthesis.
1) Measurements made with TEAC test tape MTT-111
/Metal)
2
2) Measurements made with TEAC blank test tapes MTT-
5571 (Metal), MTT-5562 (Cr0
Specifications and features subject to change without
notice or obligation.
STEREO CASSETTE DECK
120 V AC, 60 Hz
(U.S./Canada model)
230 V AC, 50 Hz (Europe model)
240 V AC, 50 Hz
(U.K./Australia model)
20W
8.4 kg (18-8/16 lbs)
± 1.0%
1
): less than 0.04% (WRMS)
Approximately 70 sec for C-60
(Frequency Response
25 Hz to 19 kHz, ±3 dB (Metal)
25 Hz to 18 kHz, ±3 dB (Cr02)
25 Hz to 16 kHz, ±3 dB (Normal)
2
): less than 1.0% at 1 kHz,
160 nWb/m (Metal)
59 dB (without NR, ref. 3%
THD level, WTD)
68 dB (Dolby-B NR, over 5 kHz)
78 dB (Dolby-C NR In, over 1 kHz)
2
): 45 dB or better (1 kHz)
2
): 65 dB or better (1 kHz)
) and MTT-5512 (Normal).
2
page 3 of 3
2
)