13.
Reposition the subpanel (rotate it 90º), then snap it back into the bezel.
NOTE:
Figure 36
14.
On the back of the Z200 Workstation front bezel, squeeze the HP logo mounting tabs (1) and press
the logo outward (2) as shown in the following illustration.
Figure 37
Rotate the HP logo 90 degrees counterclockwise, and then release the logo and press it back into
place in the front bezel.
15.
Replace the front bezel and computer access panel.
16.
Reconnect the power cord and turn on the computer.
17.
Lock any security devices that were disengaged when the computer access panel was removed.
ENWW
Your computer may look different than the illustration shown below.
Changing from a Minitower to a Desktop Configuration
Rotating the Z200 Workstation Logo
Changing from a Minitower to a Desktop Configuration
33