HP Compaq 8100 Elite Hardware Reference Manual page 31

6. Install four 6-32 isolation mounting guide screws, two on each side of the drive.
Figure 23
NOTE:
installed on the hard drive bracket under the access panel. The HP-supplied isolation mounting
guide screws are silver and blue. Refer to
of the extra 6-32 isolation mounting guide screws location.
If you are replacing a drive, transfer the guide screws from the old drive to the new drive.
7. Slide the hard drive down into the drive cage until it locks. The drivelock automatically secures the
drive in the bay.
Figure 24
CAUTION:
unnecessary force when installing any drive into the drive bay may result in damage to the drive.
ENWW
Installing the Hard Drive Guide Screws
The hard drive uses 6-32 isolation mounting guide screws. Eight extra guide screws are
Installing a Hard Drive into the Hard Drive Bay
Make sure the guide screws line up with the guide slots in the drive cage. The use of
Installing Additional Drives on page 21 for an illustration
Installing Additional Drives 25