Diamond SOUND CARD Quick Start Manual page 6

Prior to booting Into Windows
Please complete the following steps before your system boots into
Windows if your previous sound card was integrated onto your
motherboard.
1. Turn on the power to the computer and enter your systems
BIOS setup (CMOS). Please consult your system documenta-
tion for exact instructions regarding entering and using your sys-
tem CMOS.
2. Locate and disable the previous sound device. Usually this will
be listed within an Integrated Peripherals section.
3. Save and exit from CMOS.
4. Your system will reboot at this point. Let the system boot into
Windows and do not insert the installation CD until requested in
the up and coming steps.
Xtreme Sound Driver Installation
Please start your computer and do NOT insert the installation CD
until you are prompted to do so.
1. Windows will detect new hardware upon startup. Click the CAN-
CEL button on the found new hardware wizard.
2. Insert the Xtreme Sound installation CD and wait for the CD to
start.
3. Click the Install Sound Driver button.
4. A wizard will appear. Click the NEXT button to continue.
5. Confirm the installation options and click NEXT to continue.
6. Click NEXT to begin the driver installation.
7. Click OK to reboot the system.
8. Remove the installation CD.
PAGE 4