Am/Fm Antenna Connections; Network Connection; Headphones Connection - Onkyo TX-NR737 Basic Manual

connection is wrong, a bass sound may become poor due to
reverse phase. Attaching the supplied colored speaker cable
labels to the + side on the both ends of each channel's cable
will help correct connection. The subwoofer jack supports
connection of a subwoofer with built-in power amplifier. Set
the cut-off filter selection switch of the subwoofer to DIRECT.
If the subwoofer does not have a cut-off filter selection
switch but has a cut-off frequency adjusting dial, turn it to the
maximum frequency. If your subwoofer does not have built-in
power amplifier, you can connect a power amplifier between
the unit and the subwoofer.
• The speaker setting is 7.1 ch at the time of purchase. You
can change it manually or by using automatic speaker
setting.
• Short-circuiting the + cable and - cable or contacting the
cable core to the rear panel of the unit may cause failure.
Also do not connect two or more cables to one speaker
terminal or one speaker to several terminals.
• Using a speaker with less impedance than the setting
may result in failure.
When using commercially available banana plugs:
tighten the speaker terminals to the end and then insert the
banana plugs. Do not insert the cable core directly into the
hole for banana plug of speaker terminal.
(North American model)
6
3
Other connections

AM/FM antenna connections

Connect the antennas to listen to AM/FM broadcast. When
listening to the broadcast for the first time, adjust the
antenna position and orientation to get the best reception.
AM loop antenna (supplied)
Indoor FM antenna
(supplied)
Fix with a tack on
the wall.
(North American and (European, Australian
Taiwanese models) and Asian models)
Assemble the AM loop antenna (supplied).
Step 1:

Network connection

You can enjoy Internet radio and DLNA by connecting the
unit to LAN. The unit can be connected to the router with an
Ethernet cable or to the wireless LAN router with Wi-Fi
connection. In case of wired connection, connect the
Ethernet cable to the Ethernet port. See the section 2 "4th
Step : Network Connection" of "Step 2: Setting Up".
Internet radio
Router

Headphones connection

Connect stereo headphones with a standard plug (1/4
inch or ø 6.3 mm) to the PHONES jack on the front panel.
Sound from the speakers will be off while you are using the
headphones.
• If you selected any other listening mode than Pure
Audio (European, Australian and Asian models), Stereo,
Mono and Direct, connecting headphones will switch the
listening mode to Stereo.
Connections
PC
NAS