Sewing Hook-And-Loop Fastener - Brother XR9500PRW Operation Manual

■ If thick seams are being sewn and the fabric does
not feed at the beginning of stitching
Zigzag foot "J" is equipped with a feature that
keeps the presser foot level.
a Sewing direction
a When you encounter a seam that is too thick
to feed under the foot, raise the presser foot
lever.
b Press the black button on the left side of the
foot. Keep the button held in and lower the
presser foot.
a Black button
c Release the button. The foot will lock in place
level with the seam, allowing the fabric to
feed.
• Once the trouble spot has been passed, the
foot will return to its normal position.
CAUTION
● If fabric more than 6 mm (15/64 inch) thick is
sewn or if the fabric is pushed with too much
force, the needle may bend or break.
Sewing hook-and-loop
fastener
CAUTION
● Use only the ungummed hook-and-loop
fastener which is for sewing. If the glue is
attached to the needle or the bobbin hook
race, it may cause malfunction.
● If the hook-and-loop fastener is sewn with the
thin needle (65/9-75/11), the needle may
bend or break.
Note
● Before start sewing, baste together the fabric
and the hook-and-loop fastener.
Make sure that the needle passes through the hook-
and-loop fastener by turning the handwheel and
lower the needle into the hook-and-loop fastener
before sewing. And then, sew the edge of the hook-
and-loop fastener at a slow speed.
If the needle does not pass through the hook-and-
loop fastener, replace the needle with the needle for
thick fabrics (page 21).
a Edge of the hook-and-loop fastener
Meijer.com
2
33