RCF TTS26-A Instruction Manual page 8

The system is equipped with an RDNet connection on board. Using an RDNet controller unit it is possible
to:
- receive status information from the system ( amplifiers status, signal levels, system settings,...)
send commands to the system (mute, solo, change sensitivity, change setting, set user eq, ... )
-
See the RDNet user manual for details.
RDNet BY-PASS SWITCH
When the RDNet is present and the RDNet LINK LED is green the controller takes control over the module
independently of the BY-PASS SWITCH position
When the RDNet is not present, the BY-PASS switch act as follow:
- BY-PASS SWITCH pressed (LED ON):
RDNet user settings (last configuration saved).
- BY-PASS SWITCH released (LED OFF): The system reads the input board and bypass the user
setting eventually loaded ion the speaker (last configuration eventually saved).
TTS26-A DEFAULT CONFIGURATION
The TTS26-A factory default configuration (the configuration that the system reads if the BY-PASS
switch is pressed) is the following:
Sensitivity
High pass
Low pass
Cardioid
Delay
Bypass
User filters
If the user set with RDNet a new configuration, the new configuration will be recalled when the BY-PASS switch is
pressed.
BY-PASS SWITCH
ON
OFF
ON
OFF
+4 dBu
30 Hz
150 Hz
OFF
0
OFF
ALL FLAT
RDNet BY-PASS LED
ON ON
ON OFF
OFF ON
OFF OFF
The system bypass the input board and reads the
FUNCTION
Reads RDNet settings
Reads RDNet settings
Reads last saved used configuration
Reads input panel