Netis DL4311 User Manual page 49

ADSL2+ Modem Router User Manual
Next hop: Type the IPv6 address for next hop for this route. For LAN interfaces, the gateway
address must be configured and must be a directly reachable IP address on the network segment
of the selected interface. For demand-dial interfaces, the gateway address is not configured or
used.
Interface: Lists the available LAN or demand-dial interfaces. Select the one to be used to forward
the IP packet if this route is selected.
4.3.1.3 RIP:
RIP is an internet protocol you can setup to share routing table information with other routing
devices.
Choose Advanced->Route->RIP page, you can configure the RIP settings. Here you can enable or
disable the RIP function.
RIP: enable or disable the RIP function of the router.
Interface: the interface on which you want to enable RIP
Recv Version: indicate the RIP version in which information must be passed to the device it can
be accepted into its routing table
Send Version: indicate the RIP version this interface will use when it sends its route information
to the other device
44