Table of Contents
Advertisement
Battery operating time can be extended by lowering the screen refresh rate
from 60Hz to 40Hz. However, if the screen refresh rate is set to 40Hz, the
screen may flicker which could cause physical discomfort such as eye
strain. If you experience any of these problems, reset the screen refresh
rate to 60Hz.
Take short, strategically spaced rest breaks to avoid eye strain and body
fatigue. For example, stand up and walk around or stretch for a few
minutes every hour.
To change the screen refresh rate, follow the steps as detailed below:
1. Click start and click Control Panel.
2. Click Appearance and Themes and click Display to open the Display
Properties window.
3. Select the Settings window and click the Advanced button to open the
Default Monitor and Mobile Intel
4. Select the Intel
window and click the Graphics Properties button.
5. Select the Settings window, then select 40Hertz from the Refresh
Rate pull down menu and click the Apply button.
Retaining data with power off
When you turn off your computer with fully charged batteries, the batteries
retain data for the following approximate time periods:
Battery type
Battery pack (5100mAh)
High capacity battery pack
(7650mAh)
RTC battery
User's Manual
®
Graphics Media Accelerator Drive for Mobile
Retention time
State and Retention Time
about 7 days (Standby Mode)
about 100 days (Boot Mode)
about 10 days (Standby Mode)
about 150 days (Boot Mode)
30 days
Power and Power-Up Modes
®
945GM Express C... window.
6-10
Advertisement
Table of Contents
