Rear Panel Connections - Security Labs SL611 User Manual

REAR PANEL CONNECTIONS

VIDEO LINE IN
Connect the video cable coming from the video camera, monitor or other video source you wish to record here.
VIDEO LINE OUT
This can be used as an access to the video being recorded. You can connect this jack to the VIDEO INPUT on the
back of a monitor. The time and date can be viewed on the monitor if connected in this fashion.
AUDIO LINE IN
Connect the audio cable coming from your security camera, monitor, or other source you wish to record here. (A
microphone by itself may need to be amplified first.)
AUDIO LINE OUT
Not needed for recording, but can be connected as an audio source for other equipment. Connect this jack to the
AUDIO IN on a monitor with audio.
SECURITY SWITCH CONNECTIONS (Security Terminal)
Connect normally-open, normally-closed, and panic switches here. If normally-closed switches are not used, you
must leave the factory installed jumper in place so the unit will operate properly. End of tape circuits are also con-
nected here.
ANT IN
For use in conventional VCR applications. A cable TV signal is required. Cameras modulated to run on cable fre-
quencies may also be connected here. Please note that time/date will not be required with this input. (SEE 'TUNER
OPERATION BEFORE CONNECTING A CABLE INPUT)
RF OUT
You may use a standard TV for reviewing and observing. Using a standard RF cable (supplied), connect the RF
OUT to the VHF IN or ANT IN on your TV. Then by placing your TV on channel 3 or 4, you can hear and see the
audio and video of the recorder.
RF SELECT SWITCH (CH 3/4)
Set this switch to 3 or 4 corresponding to your TV viewing channel (if an RF input device or TV is used as a moni-
tor).
13