Table of Contents
Advertisement
PRODUCT SAFETY INFORMATION (continued)
15. Outdoor Antenna Grounding--If an outside antenna or cable system is connected to the product, be sure the anten-
na or cable system is grounded so as to provide some protection against voltage surges and built-up static charges.
Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regarding proper grounding of the
mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conduc-
tors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding elec-
trode.
16. Lightning--For added protection for the product during a lightning storm or when it is left unattended and unused
for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent
damage to the product due to lightning and power-line surges.
17. Power Lines--An outside antenna system should not be located in the vicinity of overhead power lines or other elec-
tric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna sys-
tem, extreme care should be taken to keep from touching such power lines or circuits as contact with them
might be fatal.
18. Overloading--Do not overload wall outlets and extension cords as this can result in a risk of fire electric shock.
19. Object and Liquid Entry--Never push objects of any kind through openings into this product as they may touch dan-
gerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the
product.
20. Servicing--Do not attempt to service this product yourself as opening or removing covers may expose you to dan-
gerous voltage or other hazards. Refer all servicing to qualified service personnel.
21. Damage Requiring Service--Unplug this product from the wall outlet and refer servicing to qualified service per-
sonnel under the following conditions:
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled or objects have fallen into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating instructions as an improper adjust
ment of other controls may result in damage and will often require extensive work by a qualified technician
to restore the product to its normal operation.
e. If the product has been dropped or the cabinet has been damaged.
f. When the product exhibits a distinct change in performance-this indicates a need for service.
22. Replacement Parts--When replacement parts are required, be sure the service technician has used replacement
parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions
may result in fire, electric shock, or other hazards.
23. Safety Check--Upon completion of any service or repairs to this product, ask the service technician to perform safe-
ty checks to determine that the product is in proper operating condition.
24. Wall or Ceiling Mounting--The product should by mounted to a wall or ceiling only as recommended by the manu-
facturer.
25. Heat--The product should be situated away from heat sources such as radiators, heat registers, stoves, or other
products (including amplifiers) that produce heat. USE ONLY IN A WELL VENTILATED AREA.
4
Advertisement
Table of Contents
