Radio Shack 8-Channel 900 MHz Wireless Receiver Owner's Manual

32-1250.RC.fm Page 1 Monday, July 9, 2001 3:53 PM
8-Channel 900 MHz Wireless Receiver
Your RadioShack 8-Channel 900 MHz Wire-
less Receiver is designed for use as a univer-
sal microphone receiver for public address
microphones or for professional music perfor-
mances. The system's long range (200 feet),
UHF operation (910–921.5 MHz), and low dis-
tortion (2.0%) let you use it anywhere you
would use a conventional microphone, and is
perfect for use with the RadioShack 8-Channel
900 MHz Wireless Microphone (RadioShack
Cat. No. 32-1251). The microphone receiver
has both LINE and MIC level outputs for easy
connection to any amplifier, mixing board, or
recorder. Plus, you can use both outputs at
the same time. The receiver's volume control
lets you easily balance the microphone's out-
puts with other sound sources.
WARNING: To reduce the risk of fire or shock hazard, do not ex-
pose this product to rain or moisture.
CAUTION
RISK OF ELECTRIC
SHOCK. DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
This symbol is intended to alert you to the
presence of uninsulated dangerous voltage
within the product's enclosure that might be
of sufficient magnitude to constitute a risk of
electric shock. Do not open the product's
case.
This symbol is intended to inform you that
important operating
!
instructions are included in the literature
accompanying this product.
You can mount the microphone receiver on an
optional Rack Mountable Accessory (Ra-
dioShack Cat. No. T32-H010001/12252664),
then mount the receiver and accessory on a
rack. See the Rack Mountable Accessory's
owner's manual for more information.
OWNER'S MANUAL — Please read before using this equipment.
If you use a rack to mount your microphone re-
ceiver, you can connect an external antenna
(RadioShack Cat. No. T32-T450/12313912)
for better reception. Connect the antenna's
BNC plug to the BNC socket on the rear panel
of your receiver, then place the antenna base
in the open site. (The antenna base is a mag-
netic material and can be attached on the
steel surface).

FCC STATEMENT

Your equipment might cause TV or radio inter-
ference even when it is operating properly. To
eliminate interference, you can try one or more
of the following corrective measures:
• reorient or relocate the receiving antenna
• increase the distance between the equip-
!
If you cannot eliminate the interference, the
FCC requires that you stop using your receiv-
er.
This device complies with Part 15 of the FCC
Rules . Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including in-
terference that may cause undesired opera-
tion.
and maintenance
Warning: Changes or modifications to this
unit not expressly approved by the party re-
sponsible for compliance could void the user's
authority to operate the equipment.
Shielded cables must be used with the unit to
ensure compliance with the Class B FCC lim-
its.
©
2001 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks
ment and the radio or TV
used by RadioShack Corporation.