General Information; Hot Water - Bunn STX Use And Care Manual

GENERAL INFORMATION

Improper set up will result in permanent damage and void the limited warranty.
Read and follow the initial set up instructions on page 4.
when cleaning.
you'll be away from home for three or more days. Safety features that are designed
in the BUNN coffee brewer make daily use of this switch unnecessary. On the NHBX,
the switch is on the lower right side (when you're facing the brewer). Press I to turn
on and O to turn off. On the STX, it is on the lower back of the brewer. To turn it on,
press in the top of the switch (I) and to turn off press in the bottom (O). The red power
light on the right front of the STX trunk will be illuminated when the power is on.
tank with water and allow the water in the tank to heat to the proper temperature
before using (about 15 minutes or until the heating sound stops).
proper temperature. This constant supply of hot water assures correctly brewed coffee.
(STX model) The brewed coffee flows into an unheated thermal carafe. The double
wall stainless steel construction will hold coffee at serving temperature for about two
stays warm.
(NHBX model) The brewed coffee flows into a glass decanter where it is kept at serving
temperature on the porcelain decanter warmer. The warmer is controlled by the lighted on/
off switch on the front of the brewer.
NOTE: The warmer switch controls only the decanter warmer.
temperature and held until needed.
water could drip from the sprayhead when cold water is poured in.
50°F hotter than what's available from your hot water faucet and is always available for
other uses.
hot, retighten the sprayhead with your fingertips.
NOTE: A severe burn may result if the sprayhead becomes loose and falls off while the
coffee is brewing.
3