Fluorescent Lamp - Panasonic FV-05VFL2 Installation Instructions Manual

1. Remove grille. (Squeeze mounting spring and pull
down) (Fig.22 of page 13)
2. Disconnect the connector
unit. (Fig.26)
3. Change the fluorescent bulbs (Panasonic FDS
18E27/4,18W or FDS18E35/4, 18W or FDS18E42/4,
18W ) or the 4W incandescent lamp, connect
II
the connector or connector
grille.(Fig.27)
Proper insulate the area around the fan to
minimize building heat loss and gain. (Fig.28)
Loose fill or batt insulation can be placed
directly over the fan housing in the attic.
Panasonic fans and fan/light combination
units do not create excessive heat that is
a common problem with recessed light
fixtures or some competitors' fan/light
combinations. Our efficient, cool-running
motors and our fluorescent bulbs do not
create enough ambient heat to be subjected
to these limitations.
Warning Concerning Removal of Covers.
The unit should be serviced by qualified technicians only. No service information is provided for customers.
Your product is designed and manufactured to ensure a minimum of maintenance. However, should your
unit ever require service, a nationwide system of factory service centers and AUTHORIZED INDEPENDENT
SERVICE CENTERS is maintained to support your product's warranty.
(In the U.S.A.,call 1-866-292-7292 to Customer call Center.)
PANASONIC CONSUMER ELECTRONICS COMPANY
One Panasonic Way, 1H-3 Secaucus, NJ 07094
PANASONIC CANADA INC.
5770 Ambler Drive, Mississauga, ON L4W 2T3
II III
or connector of light
III
and replace the
2-3 ft straight run before elbow.
In attic installation,
caulk box to drywall.
4 W Night Lamp

Fluorescent lamp

Dryer-hood type vent with
backdraft flap(s).
Caulk termination to duct.
Short piece of flexible duct
helps alignment and absorbs
sound. Clamps plus tape at
Foil tape tightly covers all metal
all flex joints.
duct joints (glue PVC joints).
14
Plug connector III
Plug connector II
Receptacle II
Receptacle III
Fig.26
Fig.27
Insulation.
Fig. 28