Orien FS-50IMOD User Manual page 27

Problem
Cubes are partially
formed or are white
at the bottom.
Noise during
operation
The ice maker stops
suddenly while
making ice.
The body of the ice
maker is electrified.
Scaling occurs
frequently inside
the machine.
Water leaks from
the ice storage bin.
Possible Cause
Not enough water in the
water trough.
The legs are not leveled and
locked.
Certain sounds are normal.
The electricity is off.
The room temperature is out
of the stated range.
The ice storage bin is full of
ice.
The ground line isn't in the
socket.
The water is too hard.
The drain hole below the ice
storage bin is blocked.
The drain hose is kinked or
improperly placed higher
than the floor of the ice
storage bin.
Probable Correction
Check if the water supply pressure is
below 15 psig.
Check water supply; filter may be
restricted.
Check for a water leak at the water
trough.
Level and lock the feet. See
"Leveling the Ice Maker".
See "Normal Sounds".
Reconnect the power supply line.
Cut off the electricity; let the ice
maker stop working until the
temperature returns to within the
stated range.
Remove some ice; be sure ice-full
probe is free of ice.
Use a socket meeting the required
electrical standard.
Using a water-softening device
installed in front of the water inlet.
Pull our the ice storage bin and clean
the drain hole.
Check the drain hose to make sure
the water can drain out unhindered.
26