Troubleshooting - NAD C 375BEE Owner's Manual

REFERENCE
TROUBLESHOOTING
CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS
--------------------
No sound.
• Power AC lead unplugged or power not · Check if AC lead is plugged in and power
switched ON.
switched ON.
• Tape Monitor selected. • De-selectTape Monitor mode.
. -
• Mute on. • Switch off Mute.
• Rear Pre-out/Main-in amp links not fitted. • Fit links.
f----------
-------
- >----_..._._-_.
No sound one channel. • Balance control not centered. • Center Balance control.
--
.
. -
• Speaker not properly connected or damaged. • Check connections and speakers.
• Input lead disconnected or damaged. • Check leads and connections.
Weak bass/diffused stereo image. • Speakers wired out of phase.
• Check connections to all speakers in the
system.
--
Remote control handset not working. • Battery fiat or incorrectly inserted. · Check or replace battery.
• IR transmitter or receiver windows obstructed. • Remove obstruction.
• IR receiver in direct sun or very bright ambient • Place unit away from direct sun, reduce
light. amount of ambient light.
Standby LED turns red during operation.
• C 375BEE has overheated. • Turn C 375BEE OFF; make sure ventilation
slots on top and bottom of C 375BEE are not
blocked. After C 375BEE has cooled down,
turn back ON.
• Overall impedance of loudspeakers too low. Ensure the overall loudspeaker impedance is
not below 4 ohms.
13