NEC ST4 User Manual

Single line telephone

Download this manual

To place a call:

Lift handset + hear dial tone + dial number

To answer a call:

Lift handset when telephone rings

Dial Mode Switch

[On bottom of phone.]

Dial Pulse

Tone Dialing

When placing a call in DP

mode, you can dial * to

change to Tone Dialing.

Wall Mounting Instructions on back.

ST4 Single Line Telephone

User Guide

Message Waiting Lamp

Lights when you have messages

waiting (if your phone system

can send them). Also flashes

when your ST4 rings.

Last Number Redial

Lift handset and press LND

to redial your last call.

Flash

While on a call, press Flash for

outside line or PBX features.

(640 mS +/- 100 mS)

Volume Control

Use the three-position

volume control to set the

loudness of ringing.

Soft

Medium

Loud

Page 1: User Guide
ST4 Single Line Telephone User Guide Message Waiting Lamp Lights when you have messages To place a call: waiting (if your phone system Lift handset + hear dial tone + dial number can send them). Also flashes when your ST4 rings.
Page 2 ST4 With Message Waiting Lamp: In addition to the information above, Your ST4 is designed for connection to a host system. Refer to the system’s installa- tion manual for instructions on connecting a single line phone. The telephone is not...
Page 3 5. ST4 With Message Waiting Lamp: In addition to the information above, The ST4 telephone is to be connected to the analog station port of a host system. The telephone is not to be connected directly to the telephone network.
Page 4 1. Push in the two retaining tabs on the bottom of the phone. 2. Slide the phone up off of the wall-mount bracket. NEC America, Inc., Corporate Networks Group 85403MBG02 April 2001 4 Forest Parkway, Shelton, CT 06484 Issue 1-0 Printed in U.S.A.