Section 7-Operation; Preparing For Treatment - Invacare Polaris EX CPAP with SoftX ISP3000 Operator's Manual

SECTION 7—OPERATION
SECTION 7—OPERATION

Preparing for Treatment

NOTE: Prior to each use, inspect the CPAP unit, air tubing, and
mask for damage, failure, or worn parts. Contact your home
healthcare provider if evidence of such is present.
1. Ensure that the Polaris EX CPAP unit power cord is
plugged into a 120 VAC (60 Hz) power outlet.
2. When the Polaris EX CPAP unit is first plugged in:
A. The software version number will be displayed on the
LCD display window for approximately one (1)
second.
B. The CPAP will display the current CPAP pressure
setting and RAMP Start Pressure for approximately
two (2) seconds (display shows pressure units in cm
H O).
2
C. "STANDBY" will then appear on the LCD display
window.
NOTE: The CPAP power indicator light will be lit whenever there
is power to the CPAP.
3. If no button has been pressed for 30 seconds, the display
intensity will diminish.
A mask should NEVER be fully connected to the unit and
worn while the CPAP unit is in the STANDBY mode.
DO NOT attach the air tubing to the mask before treat-
ment.
Invacare® Polaris™EX™
WARNING
26 Part No 1110559