Winding The Bobbin - Pfaff 90 Instruction Book

— -
nil
tOmn?tnj
th 73c66in
Disengage the sewing mechanism (see page 4) and flick
presser bar lifter to highest position. Raise the spool pins to
the vertical position. Place spool of thread on one of the
spooi pins and set bobbin on bobbin winder spindle so that
the key at base of spindle enters slot in bobbin.
Thread retainer with two holes: Pull thread from spool 1
and pass it through the holes in thread retainer 2, clockwise
around tension
3
(between the
rear
and centre tension
discs) and clockwise around bobbin 4.
Pass end of thread
through slot in bobbin, from inside. Press bobbin winder
lever toward bobbin and start winding. Having wound a
few turns, break off end of thread. Bobbin winder will stop
automatically when bobbin is full.
-
Thread retainer with four holes: Lead thread as shown by
design below.
Before you drop the machine into the cabinet or place it
in the carrying case (portable machines) the spool pins
should be swung forward to the horizontal position.