Upfitter Controls - Ford E-SERIES 2014 Owner's Manual

296
AUXILIARY SWITCHES (IF EQUIPPED)
remain running to maintain battery charge when using the upfitter
switches for extended duration or higher current draws.
When switched on, they provide 10 amps, 15 amps or 30 amps of
electrical battery power for a variety of personal or commercial uses.
A fuse and relay kit will also be included with this option. This kit
contains the required fuses and relays that need to be installed into the
power distribution box located under the hood. Refer to the instruction
sketch included in the kit. See your authorized dealer for service.
There will also be one power lead for each switch found as a blunt-cut
and sealed wire located in the underhood cowl shield above the engine
block powertrain control module.
They are coded as follows:
Switch
AUX 1
AUX 2
AUX 3
AUX 4
More detailed information about upfitter switches can be found at
https://www.fleet.ford.com/truckbbas/.
2014 Econoline (eco)
Owners Guide gf, 3rd Printing, September 2013
USA (fus)
Accessories
The upfitter option package
provides four switches, mounted in
the center of the instrument panel.
These switches will only operate
while the ignition is in the on
position, whether the engine is
running or not. However, it is
recommended that the engine
Circuit
Wire Color
Number
CAC05 Yellow
CAC06 Green with
Brown Trace
CAC07 Violet with
Green Trace
CAC08 Brown
Fuse Amp
Rating
30A
30A
10A
15A