Upfitter Controls - Ford F-150 2010 Supplement Manual

UPFITTER CONTROLS

The auxiliary switch board on the
center console makes aftermarket
customization easier, with four
prewired switches attached to the
power distribution box for electrical
accessories.
These switches are labeled AUX 1,
AUX 2, AUX 3 and AUX 4. They will
only operate while the ignition is in the on position, whether the engine
is running or not. It is, however, recommended that the engine remain
running to maintain battery charge when using the switches for extended
duration or higher current draws. When switched on by the operator
they provide 10 amps, 15 amps or 30 amps of electrical battery power
for a variety of uses.
The switches control relays and fuses that are located under the hood in
the power distribution box. Refer to the Roadside emergencies section
of your owner guide for information on fuse and relay locations. See your
authorized dealer for service.
There will also be one power lead for each switch found as a blunt-cut
and sealed wire located to the right of the glove box door and just above
the passenger side kick panel.
Additional pass through circuits that run through the dash panel to
under the hood are located in the same location.
The relays are coded as follows:
Switch Circuit number
AUX 1 CAC05
AUX 2 CAC06
AUX 3 CAC07
AUX 4 CAC08
2010 F-150 (f12)
Supplement, 1st Printing
USA (fus)
Driving
Wire color Fuse
Yellow 30A
Green with 30A
Brown Trace
Violet with 10A
Green Trace
Brown 15A
13