Table of Contents
Advertisement
FUnCtion
Rear View Camera
*
Provides a video image of the area behind the vehicle. The display
automatically appears in the touchscreen or the rearview mirror
when the vehicle is in reverse (R) and uses green, yellow and red
guides to alert you of your proximity to objects.
Front and Rear Sensing System
*
Sounds a warning tone if there is an obstacle near either bumper.
The warning tone will increase in frequency as the object gets closer.
The front sensors are active when the gearshift is in any position
other than park (P) or neutral (N) and the vehicle speed is below
6 mph (10 km/h). The rear sensors turn on when the vehicle is in
reverse (R) and is traveling less than 3 mph (5 km/h).
Lane Keeping System
*
Detects unintentional drifting out of your lane through various driver
alerts and steering corrections toward the center of the lane. Set
your system settings as desired by Mode, Sensitivity and Intensity
from your information display screen.
Driver Alert
*
Automatically monitors your driving behavior using various
inputs including the front camera sensor. If the system detects
that your driving alertness is reduced below a certain threshold,
the system will alert you by using a tone and displaying a message
in the information display. If no correction is made, warnings will
continue to alert the driver. Press OK on the steering wheel to clear
the warning.
collision Warning System
*
Designed to alert the driver of certain collision risks. A radar detects
if your vehicle is rapidly approaching another vehicle traveling in the
same direction as yours. If it is, a red warning light displays and an
audible warning tone sounds. If the risk of collision increases, the
system will increase brake support to help reduce collision speed.
BLIS
(Blind Spot Information System)
®
with cross Traffic Alert
*
BLIS aids you in detecting vehicles that may have entered into your
blind spot zone. Cross traffic alert warns you of vehicles approaching
from the sides when the transmission is in reverse (R). BLIS and
cross traffic alert turn on a yellow indicator light in the exterior mirror
on the side of the vehicle the approaching vehicle is coming from.
Refer to the Driving Aids chapter in your Owner's Manual for
more information.
Note
Visibility aids do not replace the need to watch where
the vehicle is moving. Refer to your Owner's Manual for safety
information, more details and system limitations.
*if equipped
ComFoRt
Heated Front Seats
*
to access, press the Climate corner on the touchscreen. For heated
front seats, press
repeatedly to cycle through the various heat
modes and off. if your vehicle is not equipped with a touchscreen,
use the hard button controls (indicated by the same symbol) to
cycle through the various heat modes and off.
Memory Function
*
Use the memory controls located on the driver's door to program
and then recall memory positions. move the seats and mirrors to
the desired positions. to program up to 3 positions, press and hold
the desired pre-set button until you hear a single tone. you can
now use these controls to recall the set positions.
Moonroof
*
your moonroof controls are
located on the overhead
console and have a one-touch
open and close feature.
To open the moonroof, press
the
. it will stop short of the
fully opened position to help
reduce wind noise.
To close, press the
.
To use the venting feature,
press the
button.
Tilting Head Restraints
your vehicle's front head restraints have
a tilting feature for extra comfort.
To Tilt the Head Restraint
adjust the seatback to an upright driving
or riding position. Pivot the head restraint
forward toward your head to the desired
position. once it is in the forward-most
position, tilting it forward once more will
release it to the upright position.
Note
do not attempt to force the head restraint backward after
it has been tilted. instead, continue tilting it forward until the head
restraint releases to the upright position.
Ambient Lighting
*
lights various places, such as the footwells, with a choice of colors.
Access Using Your Touchscreen and Make Your Adjustments
1. Press the settings icon > Vehicle > ambient lighting.
2. touch the desired color.
3. Use the scroll bar to increase or decrease the intensity.
to switch off the feature, press the power button.
*if equipped
15
Advertisement
Table of Contents
