Replacing The Rear Fan Assembly - Lenovo ThinkStation Hardware Maintenance Manual

7. Insert the two tabs
and then press the two tabs through the holes until the bracket is secured in place.
Figure 36. Installing the new front fan assembly bracket
8. Connect the front fan assembly cable to the front fan connector on the system board. See "Locating
parts and connectors on the system board" on page 71.
9. To complete the installation or replacement, go to "Completing the parts replacement" on page 109.

Replacing the rear fan assembly

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety
information" in the ThinkStation Safety and Warranty Guide that came with your computer. To obtain a copy
of the ThinkStation Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the rear fan assembly.
Note: Your computer supports two rear fan assemblies.
1 on the new front fan assembly bracket into the corresponding holes in the chassis,
.
Chapter 9 Replacing FRUs
105