Honda Accord Coupe 2000 Owner's Manual page 225

Main Menu
Table of Contents
Cooling System
5. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator.
6. 4-cylinder models
Put a new washer on the drain bolt,
then reinstall the drain bolt in the
engine block. Tighten it securely.
Tightening torque:
61 lbf.ft(83N . m,8.5kgf.m)
6-cylinder models
Tighten the drain bolt at the rear
of the engine cylinder block
securely.
Tightening torque:
7 lbf.ft (10 N . m, 1.0 kgf.m)
Maintenance
7. Mix the recommended antifreeze
with an equal amount of purified
or distilled water in a clean
container. The cooling system
capacity is:
4-cylinder models
With 5-speed manual transmission:
1.45 US gal (5.5 ,1.21 Imp gal)
With automatic transmission:
1.43 US gal (5.4 ,1.19 Imp gal)
6-cylinder models
1.48 US gal (5.6 ,1.23 Imp gal)
BLEEDER BOLT
8. 4-cylinder models
Loosen the bleeder bolt on top of
the engine.
Pour coolant into the radiator.
Tighten the bleeder bolt when
coolant comes out in a steady
stream with no bubbles.