Setting Up A Static Ip Address From The Bios Setup Utility - HP ProLiant Lights Out-100 User Manual

Setting up a static IP address from the BIOS Setup Utility

By default, LO100 has DHCP enabled and automatically negotiates an IP address. To disable
DHCP and enable a static IP address:
1. Press the F10 key during POST to enter the BIOS Setup Utility.
2. Press the right arrow (→) key to navigate to the Advanced menu.
3. To set your network BIOS settings, choose one of these options:
On ML1 10 G6 and DL120 G6 servers:
a.
b.
c.
On ML150 G6 servers:
a.
b.
c.
d.
On DL160 G6, DL160se G6, DL180 G6, and SL160z G6 servers:
a.
b.
c.
d.
On DL170h G6, SL170z G6, SL170s G6, DL170e G6, and SL2x170z G6 servers:
a.
b.
c.
d.
◦
On DL165 G7 and And SL 165 G7 servers:
a.
b.
c.
d.
◦
4. Press the F10 key to save and exit.
To restore DHCP, see "Configuring network settings using the BIOS Setup Utility."
12 Configuration
Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
Press the down arrow (↓) key to scroll to the LAN Settings menu. Press the Enter key.
On IP Address Assignment, select Static.
Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
Press the down arrow (↓) key to scroll to the end, and then select BMC LAN
Configuration.
On BMC LAN Configuration, select Static.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet
mask, and gateway address (press the Tab key to move between address fields).
Press the down arrow (↓) key to scroll to IPMI. Press the Enter key.
Press the down arrow (↓) key to scroll to the LAN Configuration menu. Press the Enter
key.
On DHCP IP Source, select Disabled.
Press the down arrow (↓) key to scroll down and enter a valid IP address, subnet
mask, and gateway address (press the Tab or period (.) key to move between address
fields).
Press the down arrow (↓) key to scroll to IPMI Configuration. Press the Enter key.
Press the down arrow (↓) key to scroll to the LAN Configuration menu. Press the Enter
key.
Press the down arrow (↓) key to scroll to the end, and then select DHCP IP Source.
Select either of the following:
To set BMC NIC to Disabled, press the Enter key.
Press the down arrow (↓) key to scroll to IPMI Configuration. Press the Enter key.
Press the down arrow (↓) key to scroll to the LAN Configuration menu. Press the Enter
key.
Press the down arrow (↓) key to scroll to the BMC LAN Configuration menu. Press
the Enter key.
Select DHCP/static, then press the Enter key.
To save all changes and exit, press the F10 key. To save all changes and exit, press
the F10 key.