Table of Contents
Advertisement
Rev 3.0E Mar.10
Light Patterns
The LEDs on the front of the modem will respond in different patterns to indicate
modem states.
•
Normal - Each LED, mentioned above, is lit as applicable.
•
Start up - The LEDs will cycle from left to right.
•
PassThru mode - Network and Signal LEDs will blink in tandem. The
Activity LED will blink when transmitting or receiving data.
•
SOS - The Network LED blinks.
•
Configuration Reset - The LEDs will cycle left to right and then right to left 4
times.
•
Authentication Failure - The Network, Signal, and Activity LEDs blink every
2 seconds.
•
Data Retry - The Network, Signal, and Activity LEDs blink every 3 seconds.
Optional: Setting up a DUN Connection
Dial-up Networking (DUN) allows a computer or other device to use the serial port
or USB virtual serial port on your Raven XT to connect to the Internet or private
network using PPP just like an analog modem using a standard phone line.
To install any driver on your computer, you may need to be logged in as Admin-
Caution:
istrator or have Administrator privileges for your login.
Microsoft Windows XP is used in the examples below. The modem driver
installation and DUN setup and configuration is similar in Microsoft Windows
products. Examples are not provided here for installing the driver or configuring
DUN for any other operating system.
\
Standard installations of Microsoft Windows XP and 2000 include a generic
device driver which will work with your Raven XT.
1. Connect the Raven XT.
a. Connect the device to the computer with a DB-9 cable or the USB port in
serial mode.
b. Plug in the AC adapter, connect the antenna(s) and power on the device.
2. Install the driver.
a. Select Start > Control Panel > Phone and device Options (in Classic
View).
29
Advertisement
Table of Contents
