Table of Contents
Advertisement
Raven XT
34
Figure 0-15: device Properties: device
c. Maximum Port Speed should be set to 115200 (default).
d. Select OK to exit.
e. Select OK again to exit out of the Phone and device Options.
Creating a Dial-Up Networking (PPP)
Connection
Once you have the driver for the modem installed on your computer, you can set
up and configure Dial Up Networking (DUN) to use the modem as your
connection to the Internet using PPP.
Note: No other device or program can be using the same COM port (serial port)
configured for the modem driver.
If you have an existing LAN connection, installing DUN for the modem may
Caution:
interfere with the LAN connection. It's recommended to disconnect your LAN connection
before using a PPP connection with your Raven XT.
Once the DUN connection is initiated, by default, it will take over as the "default
route" for network communication and specifically for Internet access. If you want
the two connections to co-exist, you will need to de-select "Use default gateway
on remote network" (described later) and use the route command in Windows to
setup routing through the modem properly. This guide does not provide
information on the route command. You may need to consult with your network
administrator to properly configure routing.
20070914
Advertisement
Table of Contents
