Recognizing Preset Display Resolutions; L6015Tm And L6017Tm; Entering User Modes; Energy Saver Feature - HP L6015tm User Manual

Recognizing Preset Display Resolutions

The display resolutions listed below are the most commonly used modes and are set as factory
defaults. This monitor automatically recognized these preset modes and they will appear properly
sized and centered on the screen.

L6015tm and L6017tm

Table B-4
Preset Pixel Format
1 640 × 480
2 720 × 400
3 800 × 600
4 1024 × 768
5 1280 × 1024
(L6017tm only)

Entering User Modes

The video controller signal may occasionally call for a mode that is not preset if:
●
You are not using a standard graphics adapter.
●
You are not using a preset mode.
If this occurs, you may need to readjust the parameters of the monitor screen by using the on-screen
display. Your changes can be made to any or all of these modes and saved in memory. The monitor
automatically stores the new setting, then recognizes the new mode just as it does a preset mode. In
addition to the 4 or 5 factory preset, there are 10 user modes that can be entered and stored.
The only condition to store as a user mode is the new display information must have 1 KHz difference
for horizontal frequency or 1 Hz for vertical frequency or the sync signal polarities are different from
the default modes.

Energy Saver Feature

When the monitor is in its normal operating mode, the monitor uses less than 21 watts and the Power
light is green.
The monitor also supports a reduced power state. The reduced power state will be entered into if the
monitor detects the absence of either the horizontal sync signal and/or the vertical sync signal. Upon
detecting the absence of these signals, the monitor screen is blanked, the backlight is turned off, and
the power light is turned amber. When the monitor is in the reduced power state, the monitor will
utilize less than 1 watt of power. There is a brief warm up period before the monitor will return to its
normal operating mode.
Refer to the computer manual for instructions on setting energy saver features (sometimes called
power management features).
NOTE: The above power saver feature only works when connected to computers that have energy
saver features.
28 Appendix B Technical Specifications
Factory Preset Modes
Horz Freq (kHz)
31.469
31.469
37.879
48.363
63.981
Vert Freq (Hz)
59.940
70.087
60.317
60.004
60.020