Listening To Your Non-Docking Ipod Or Other Portable Audio Device - Altec Lansing M202 User Manual

Listening to Your non-docking iPod or Other Portable Audio Device

If you have a third audio device, you can enjoy it through your Altec Lansing
Octiv Duo speaker system as well. Just connect it via the AUX jack.
Here's how:
1
Locate a 3.5mm stereo
cable (not included).
2
Plug one end of the stereo
cable into your device.
Your device should have either
a headphone or LINE OUT
jack for you to plug into.
3
Plug the other end of
the stereo cable into
your speaker system's AUX jack.
The AUX jack is located on the back of the unit.
4
Turn on your speaker system.
Press the button.
5
Select "AUX" mode.
Press the "SOURCE" button on your speaker system or the full-
featured remote until the "AUX" LED lights up.
6
Turn on your device and start it playing.
7
Adjust the volume.
Use the "+" and "–" buttons on the speaker system or the "VOL +"
and "VOL –" buttons on the full-featured remote to adjust the volume.
NOTE You may need to adjust the device volume also. Your device's
volume should be set to approximately ¾ volume.
8
When you are finished listening to your portable audio device,
please remember to turn both it and your speaker system off
to conserve electricity.
11