Horizon Fitness EX-67 User Manual page 5

AS SE MB LY ST EP 2
GUIDE RAIL CAPS
NOTE: There is NO hardware bag for this step.
A) Slide GUIDE RAIL CAPS into the GUIDE RAIL to seal the openings.

EX-67_Rev.1.6.indd 8-9
ASSEMBLY STEP 
FOOTPAD
LINK ARM
SCREWS (F)
A) Open HARDWARE BAG FOR STEP 3.
B) Attach FOOTPAD to PEDAL ARM using 4 SCREWS (F).
C) Align the bracket on the RIGHT LOWER LINK ARM with the tube on the RIGHT PEDAL ARM.
D) Slide the SPACER (R) through the LINK ARM BRACKET and the PEDAL ARM so it can't rotate.
E) Insert 2 WASHERS (S) between the PEDAL ARM and the LINK ARM BRACKET.
F) Secure the joint with a FLAT WASHER (U) and BOLT (T).
G) Attach PEDAL ARM to the CRANK with 1 BOLT (G), 1 WASHER (I), 1 WAVY WASHER (D) and 1 WASHER (H).
H) Repeat on other side.
HARDWARE BAG FOR STEP  CONTENTS :
SCREW (F) BOLT (G)
12 mm 13 mm
Qty: 8 Qty: 2
WASHER (S) WASHER (U) WASHER (H)
30 mm 35 mm Qty: 2
Qty: 4 Qty: 2
WASHER (H)
WASHER (I) BOLT (G)
CRANK
WAVY WASHER (D)
RIGHT LOWER LINK ARM
RIGHT PEDAL ARM
WASHERS (S)
BOLT (T)
SPACER (R)
WASHER (U)
WASHER (H)
WASHER (I) BOLT (G)
BOLT (T) SPACER (R)
15 mm 70 mm
Qty: 2 Qty: 2
CRANK
WAVY WASHER (D)
WASHER (I) WAVY WASHER (D)
Qty: 2 Qty: 2
RIGHT LOWER LINK ARM
RIGHT PEDAL ARM
angle view
WASHERS (S)
BOLT (T)

7/7/08 4:29:13 PM