Wiring - Panasonic CQ-D1703W Operating Instructions Manual

E

Wiring

N
G
L
I
S
H
39
¡ Exclusively operated with 12 V battery with negative (–) ground.
¡ Connect the power lead (red) very last.
¡ Connect the battery lead (yellow) to the positive (+) terminal of the battery or fuse block terminal (BAT).
¡ Apply insulating tape to bare leads.
¡ Secure loosened leads.
Connecting the Parking Brake Connection Lead
Caution
¡ For safety, be sure to ask your nearest professional installer to do this connection.
Hand brake
The parking brake switch position varies with the car
model.
For details on the exact location of the parking brake
switch in your car, contact your dealer.
Parking Brake Lead
(Blue/yellow stripe)
When the parking brake lever is
engaged, the unit is grounded by the
chassis.
PARKING BRAKE
When connecting this unit to the rear monitor:
¡ The parking brake lead and grand lead should be connected to the same terminal.
Connect as follows
¡ Use ungrounded speakers only.
Allowable input: 50 W or more
Impedance: 4 – 8 Ω
¡
Distance between speaker and amplifier: 30 cm or more
¡ Do not use a 3-wire type speaker system having a common
earth lead.
40
CQ-D1703W
Before Wiring
Foot brake
Brake light
Battery
+
Clip Connector y
Car chassis
Speaker Connection
q Attach a Clip Connector y to the end
Parking brake
switch
w The Clip Connector y is connected to
–
Power source side lead
Caution
¡ Do not connect more than one speaker to one set of
speaker leads. (except for connecting to a tweeter)
of the parking brake connection lead.
Parking Brake Lead
(Blue/yellow stripe)
the power source side lead of the park-
ing brake.