Mount into the dashboard
Note
•
Make sure that wires are correctly connected before
you mount the main unit into a car.
•
If preset radio stations are lost when the ignition key
is turned OFF and then back ON, reconnect the red
leads crosswise to the yellow ones.
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative terminal
of the car battery.
•
If you disconnect the car battery in a car that has
an on-board drive or navigation computer, the
computer may lose its memory.
•
If the car battery is not disconnected, to avoid
short-circuit, make sure that bare wires do not
touch each other.
2
Make sure that the car dashboard opening is within
these measurements:
•
Since the unit cannot be used if the dashboard
opening's slant angle is above 20 degrees, make
sure that the horizontal slant of the car dashboard
opening is between 0 and 20 degrees.
3
Remove the mounting sleeve with the supplied
disassembly tools.
4
Install the sleeve into the dashboard and bend the tabs
outward to fix the sleeve.
•
If the system is not fixed by sleeve but by the
supplied screws, skip this step.
5
Slide the unit into the dashboard until a click sound is
heard.
6
Attach the trim plate.
7
Reconnect the negative terminal of the car battery.
EN
7