Sanyo PLC-XU106 Owner's Manual page 52

Setting
Ceiling
When this function is set to On, the picture will be top/
bottom and left/right reversed. This function is used to
project the image from a ceiling-mounted projector.
Rear
When this function is set to On, the picture will be left/right
reversed. This function is used to project the image from
rear of the screen.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready.................. When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the top control or remote control is
pressed.
Shut down .......... When the lamp has been fully cooled
down, the power will be turned off.
Off ....................... Power management function is off.
Timer................... If the input signal is interrupted and
no button is pressed for more than
30 seconds, the timer display with No
signal appears. It starts the countdown
until the lamp is turned off. Use the Point
Note:
Factory default is Ready: 5 Min.
52
buttons to set the Timer(1~30Min.).
Ceiling
Rear
Power management
Time left before Lamp is off.
an a e
Men position
A to set p
e stone
Bac ro n
isp a
o o
ei in
ear
o er mana ement
n start
ose caption
Stan
n is
B e
n
n
n
1
mo e co
1 2