Separate Purchase - LG LM86 Series Owner's Manual

14
ASSEMBLING AND PrEPArING
CAUTION
y If there is a Isolator, follow as shown.
y
» Use this to install TV in a place where there is a voltage difference between TV set and GND of
antenna signal. If there is a voltage difference between TV set and GND of antenna signal, the
antenna contact might be heated and excessive heat might cause an accident.
» You can improve the safety when watching TV by efficiently removing power voltage from TV
antenna. It is recommended to mount the isolator to the wall. If it cannot be mounted to the wall,
mount it on the TV. Avoid disconnecting the antenna Isolator after installation.
» Before starting, be sure that the TV antenna is connected.
Wall
ANTENNA/
CABLE IN
Cable / Antenna
Isolator
Connect one end of the isolator to cable/antenna jack and the other to TV set or set-top box.
"Equipment connected to the protective earthing of the building installation through the mains
connection or through other equipment with a connection to protective earthing - and to a cable
distribution system using coaxial cable, may in some circumstances create a fire hazard. Connection
to a cable distribution system has therefore to be provided through a device providing electrical
isolation below a certain frequency range (galvanic isolator, see EN 60728-11)"
When applying the RF Isolator, a slight loss of signal sensitivity can occur.

Separate purchase

Separate purchase items can be changed or modified for quality improvement without any notification.
Contact your dealer to buy these items.
These devices only work with certain models.
P
AN-Mr300
Magic remote control
The model name or design may be changed depending on the upgrade of product functions,
manufacturer's circumstances or policies.
or
AG-F2 ** , AG-F3 **
Cinema 3D glasses
Connect to TV.
Connect to Set-Top box.
AG-F2 ** DP, AG-F3 ** DP
Dual play glasses