Table of Contents
Advertisement
2 - 7
Hard surface floor cleaning
The power nozzle can be used for
cleaning hard surface floors such as
wood, linoleum, vinyl, asphalt and rub-
ber tile, sealed cork, concrete and ter-
razzo, as well as carpet.
To set the power nozzle for hard surface
floor cleaning, push the floor surface
selector button toward "BARE" (E). This
setting provides suction and no agitator
action. If you prefer, you may use the
wall/floor brush to clean bare floors.
You will find it particularly convenient
when cleaning lightweight area rugs to
set the floor surface selector button on
"BARE" and continue cleaning the sur-
rounding floor surfaces.
Note: The headlight will be ON in both
the "RUG" and "BARE" floor surface
.
modes
2 - 1 0
G
Suction regulator
(some models)
The suction regulator on the wand
allows the user to reduce suction when
necessary. Open the suction regulator
for less suction when cleaning light-
weight fabrics or throw rugs. Close (G)
the suction regulator for maximum suc-
tion.
If the power nozzle is difficult to push
on some carpet,open the suction reg-
ulator. This will help prevent damage
to the belt.
6
2 - 8
E
Edge cleaning
Special edge groomers are provided on
both sides of the nozzle to remove dirt in
carpet near baseboards and furn i t u re .
Guide side of nozzle parallel to edge of
carpet or furn i t u re as shown.
Cleaning tools
The cleaning tools are conveniently
stored in the cleaner underneath the tool
lid. Pull up on edge of lid in recessed
area to open.
The lid is also designed with a "break-
away" feature which allows it to snap off
if it is pushed open too far. To re-attach,
align small knobs on hinge area of lid
with slots at rear of cleaner; press lid
back into place.
The cleaning tools have many uses.
Select the tool best suited for the clean-
ing task from the following descriptions.
2 - 1 1
I
K
H
L
J
2 - 9
Variable speed control
(some models)
The variable speed control (F) is located
on the hand grip.
Slide the control back to reduce energ y
consumption and to clean lightly soiled
a reas or delicate fabrics. Slide control for-
w a rd for maximum cleaning power in
heavily soiled areas. If the power nozzle is
d i fficult to push, slide the control toward
back to reduce the pow e r. This will help
p r event damage to the belt.
Select the proper tool
H. Crevice tool may be used in tight
spaces, corners, and along edges in
such places as dresser drawers, uphol-
stered furniture, stairs and baseboards.
I. Furniture nozzle may be used for
upholstered furniture, draperies, tapes-
tries, mattresses and clothing.
J. Dusting brush may be used for
carved furniture, table tops, books,
lamps, lighting fixtures, venetian blinds,
baseboards, shutters and registers.
K. Hard floor tool may be used for
walls and very irregular hard surface
floors such as brick and slate.
L. Powered hand tool may be used for
upholstered furniture, carpeted stairs,
and hard to reach places.
F
Advertisement
Table of Contents
