Sharp XV-Z10000 Service Manual page 25

No. Adjusting point
6 Video bright-
ness/contrast
adjustment
7 Video TINT
adjustment
8 NTSC color
saturation
adjustment
9 PAL color
saturation
adjustment
10 SECAM color
saturation
adjustment
11 Check and
readjustment of
white balance
12 Color-related
operation check
13 Video-related
operation check
14 Operation check
of RGB
Adjusting conditions
1. Select the following group
and subject.
Group: VIDEO1
Subject: AUTO
1. Input split color bar signal.
INPUT 4
2. Select the following group
and subject.
Group: VIDEO 1
Subject: TINT
1. Input split color bar signal.
INPUT 4
2. Select the following group
and subject.
Group: VIDEO1
Subject: N-COLOR
1. Input the PAL color bar.
INPUT 4
2. Select the following group
and subject.
Group: VIDEO1
Subject: P-COLOR
1. Input the SECAM color bar.
INPUT 4
2. Select the following group
and subject.
Group: VIDEO1
Subject: S-COLOR
1. Use the adjustment condi-
tions in the item 6.
1. Receive the color bar.
1. Receive the monoscope.
1. Receive the RGB signal.
Adjusting procedure
By selecting AUTO with the control SW or the button
on the remote control after inputting the signal, it is
automatically adjusted.
1. Check the fixed value.
Fixed value: 120
1. Check the fixed value.
Fixed value: 100
1. Check the fixed value.
Fixed value: 100
1. Check the fixed value.
Fixed value: 90
Check that there is no deviation of white balance with
the monitor.
1.Select L1 of the process mode LINE. Operation check
of Color and Tint.
1.Select L2 of the process mode LINE. Check of Pic-
ture, Bright, and Sharpness.
1.Select L4 of the process mode LINE. Check of Pic-
ture, Bright, Red, Blue, Clock, Phase, H-POS, V-POS.
25
XV-Z10000