Cabinet Disassembly Instructions - Toshiba D-R410KU Service Manual

CABINET DISASSEMBLY INSTRUCTIONS

1. Disassembly Flowchart
This flowchart indicates the disassembly steps to gain
access to item(s) to be serviced. When reassembling,
follow the steps in reverse order. Bend, route, and
dress the cables as they were originally.
[1] COVER TOP
[2] PANEL FRONT
[3] BOARD FRONT
[4] BOARD POWER
SWITCH
[5] DVD MECHANISM
& DVD MAIN BOARD
ASSEMBLY
[6] BOARD POWER
SUPPLY
[7] PANEL REAR
[8] BOARD AV
[9] BRACKET R FRONT
2. Disassembly Method
ID/
Loc. Part
Fig.
No.
No.
[1] COVER TOP D1 6(S-1)
PANEL
[2] D2
FRONT
BOARD
[3] D2 4(S-2), *CN3002
FRONT
BOARD
[4] POWER D2 (S-3)
SWITCH
DVD
MECHANISM
[5] & DVD MAIN D3
BOARD
ASSEMBLY
BOARD
[6] POWER D4 4(S-7)
SUPPLY
PANEL
[7] D5 (S-8), 6(S-9)
REAR
[8] BOARD AV D5
NOTE: BOARD MEANS PRINTED CIRCUIT BOARD.
Removal
Remove/*Unhook/
Unlock/Release/ Note
Unplug/Desolder
---
*5(L-1), *3(L-2),
*CN2204
---
---
4(S-4), (S-5), (S-6),
*CN101, *CN701,
*CN901, *CNA02,
BOARD SUPPORT/
BOARD SPACERS,
M-BOARD PLATE
EARTH
---
---
5(S-10), 2(S-11),
DV JACK, ---
DV PLATE EARTH
ID/
Loc. Part
No.
BRACKET
[9]
R FRONT
↓ ↓
(1) (2)
Note:
(1) Identification (location) No. of parts in the figures
(2) Name of the part
(3) Figure Number for reference
(4) Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P = Spring, L = Locking Tab, S = Screw,
CN = Connector
* = Unhook, Unlock, Release, Unplug, or Desolder
e.g. 2(S-2) = two Screws (S-2),
2(L-2) = two Locking Tabs (L-2)
(5) Refer to "Reference Notes."
Reference Notes
1. CAUTION 1: Locking Tabs (L-1) and (L-2) are
fragile. Be careful not to break them.
2. CAUTION 2: The DVD MECHANISM & DVD MAIN
BOARD ASSEMBLY is adjusted as a unit at
factory. Therefore, do not disassemble it. Replace
1
the DVD MECHANISM & DVD MAIN BOARD
ASSEMBLY as a unit.
[1] COVER TOP
(S-1)
2
1-5-1
Removal
Remove/*Unhook/
Fig.
Unlock/Release/
No.
Unplug/Desolder
D5 (S-12)
↓ ↓
(3) (4)
(S-1)
(S-1)
Fig. D1
E7K7ADC
Note
---
↓
(5)