Supervisor Password - Toshiba TECRA A8 User Manual

■
Disable (button)
Click this button to invalidate the token. You cannot re-validate old
tokens, but you can use the same SD cards to create new tokens.
After using the token created for authentication, do not leave it inserted in
the SD card slot, ensure that the token is removed from the slot and stored
in a safe location. If the token is left in the slot, there is a danger of theft or
a third party using it for authentication and operating the user's computer
(resulting in extraction, modification or deletion of data) when the user is
not at their desk.

Supervisor Password

If you set a Supervisor Password, some functions might be restricted when
a user logs on with the User Password. To set a Supervisor Password,
execute the file TOSPU.EXE. The file is located at:
C:\Program Files\Toshiba\PasswordUtility\TOSPU.exe
This utility lets you do the following:
■
Register, delete or change the Supervisor Password.
■
Create or invalidate a Supervisor Password token.
This function in the TOSHIBA Password Utility lets you invalidate only
supervisor tokens or all tokens, including user and supervisor tokens.
■
Specify restrictions for general users.
Starting the computer by password
If you have already registered a password, there are two ways to start the
computer:
■
Insert an SD card token before you turn on the computer. The computer
will start normally, without displaying a password prompt.
■
Enter the password manually.
The password is necessary only if the computer was Shutdown and
Hibernation in boot mode.
It is not needed in Sleep Mode and Restart.
To enter a password manually, follow these steps:
1. Turn on the power as described in Chapter 3,
following message will appear in the LCD:
S
2. Enter the Password.
3. Press Enter.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
User's Manual
Password=
Power and Power-Up Modes
Getting Started. The
6-14